New hydraulic pumps and motors
Hydraulic motorsHydraulic pumps
Bearings
O-rings
Rotary Groups
Seals Valves
Valve blocks
Hydraulic pump and motor refurbishments
Hydraulic pumps and motors can be repaired and refurbished.State of the art hydraulic workshop
Only genuine parts are used
Units are tested to Manufacturers specifications
Units are supplied with warranty
Hydraulic testbed
The installed power of the pump test stand exceeds
that required to test the largest hydraulic piston pumps manufactured to
date. The unique 2 station system is fully independent and can test
open and closed circuit pumps and motors, sizes ranging from 12cc/rev
to 1000cc/rev of pressures up to 450bar.
The master control panel collates all the test
information required via a 32 channel data acquisition system. The
instrumentation system records 7 flows up to 100°C, 2 speeds up to 4000
rpm. 1 drive for Electro hydraulic pump controls, 1 power output in
HP/KW and time. We can provide hard copy graphical test reports, showing
overall performance and efficiencies.
Pump controls can be set to your specifications no
matter how complex, including; horsepower regulated, load sensing,
pressure compensated etc.
Hydraulic motor testbed
The motor test stand is based upon a hydrostatic
dynamometer and is capable of testing units up to 250cc/rev or 1800Nm.
The instrumentation on this stand includes flow, pressure, temperature,
speed and output torque, combined with data recording equipment.
Hydraulic valve test rig
All hydraulic valve types can be tested and set to
your specification on the valve test stand including
electro-proportional, flapper-servo, electrical solenoid, hydraulic
pilot, pneumatic and manual operation. The test rig has the mounting
plates for all popular sizes ISO, DIN. And CETOP standards, for both
directional and relief/reducing valve types.
Hydraulic pump and motor service exchange program
PT.CALTAV INDONESIA offers a range of service
exchange hydraulic pumps and motors, which are fully tested and ready to
be dispatched. The bulk of service exchange units, usually represent
the older designs and specifications that are more difficult to source
than the current day generation.
The service exchange programme relies on the return
of the original unit, with serviceable cast housings, therefore allowing
the programme to continue. We are also technically capable of updating
your old out of date equipment with new versions from the same
manufacturer of supply cost effective replacements.
Hydraulic pump and motor manufacturers covered
AtosBarnes
Bosch
Brueninghaus
Cassappa
Caterpillar
Cessna
Char-lynn
Commercial
Daikin
Danfoss
Denison
Dowty
Dusterloh
Eaton
Hamworthy
Hawke
HPI
Hydac
Hydraulic Ring
Hydrokraft
Hydromatik
Hydrostatic Transmissions
Kawasaki
Komatsu
Liebherr
Linde
Mannesmann Rexroth
Nachi
Parker Hannifin
Permco Pleiger
Poclain
Powerteam
Racine
Rexroth
Rollstar
Salami
Sauer Danfoss
Sauer Sundstrand
Staffa
Uchida
Ultra
Valmet
Van Roll
Vickers Vane
Voac
Voith
Volvo
Wandfluh
Offshore crane hydraulic pumps and motors
PT.CALTAV INDONESIASumatera Convention Center
5th Floor Room 506
Jln.Engku Putri No.1, Batam Center
29464 Batam
Indonesia
Tel : +62 778 470006
Fax : +62 778 470006
Mobile: +62 813 7222 2944
email : isra.junaidi@caltav.com
Website : http://www.caltav.com